Step 16 Connect the power cables. For details, see 3.5 Connecting Cables to a PSU.
Step 17 Power on the server. For details, see 3.1 Powering On the Server.
Step 18 Log in to the iBMC WebUI, and check whether the new component is normal. For details, see
the TaiShan Rack Server iBMC User Guide.
----End
5.7 Supercapacitor
To install a supercapacitor, perform the following steps:
Step 1 Wear an ESD wrist strap. For details, see 12 Preventing Electrostatic Discharge.
NOTE
Before installing a supercapacitor, power off the server for electrical safety.
Step 2 Power off the server. For details, see 3.2 Powering Off the Server.
Step 3 Remove the power cables. For details, see 3.4 Removing Cables from a PSU.
Step 4 Remove the server. For details, see 3.3 Removing the Server and Guide Rails.
Step 5 Remove the chassis cover. For details, see 3.6 Removing the Chassis Cover.
Step 6 Take a spare supercapacitor out of its ESD bag.
Step 7 Place the supercapacitor downwards and exert even force to install it in the tray. Ensure that
the supercapacitor is secured by the latches. See Figure 5-13.
Figure 5-13 Installing a supercapacitor
Step 8 Secure the supercapacitor to the air duct. See Figure 5-14.
TaiShan 2280 V2 Server
User Guide
5 Optional Part Installation
Issue 01 (2019-07-01) Copyright © Huawei Technologies Co., Ltd. 94
To Next Page
Loading...
