Step 4 Keep the key properly.
----End
5.3 Drive
l For details about drive slot numbers, see 2.9 Drive Slot Numbers and Indicators.
l To ensure drive availability, the storage duration of a drive cannot exceed six months
before use.
l If drives of different models are installed in one server and the customer has no special
requirements, observe the following rules:
– Use the Intelligent Computing Compatibility Checker to query the types of
supported drives.
– A RAID array supports only drives of the same model. It is recommended that
drives in one server be of the same type and capacity, but SAS and SATA drives can
be installed in the same server.
– If drives of different capacities and the same type are to be installed in one server,
install small-capacity drives first and then large-capacity drives.
5.3.1 Removing a Drive
Step 1 Wear an ESD wrist strap. For details, see 12 Preventing Electrostatic Discharge.
NOTE
l You do not need to power off the server when removing a drive.
l Before removing a drive, determine its location to prevent misoperations.
Step 2 If the server is equipped with a front bezel, remove the bezel before removing a front drive.
For details, see 5.2.1 Removing the Front Bezel.
Step 3 Press the ejector release button on the drive. See (1) in Figure 5-5.
The ejector lever automatically ejects.
Figure 5-5 Removing a drive
TaiShan 2280 V2 Server
User Guide
5 Optional Part Installation
Issue 01 (2019-07-01) Copyright © Huawei Technologies Co., Ltd. 87
To Next Page
Loading...
