Figure 5-21 Installing a FlexIO
Step 8 Tighten the screw using the Phillips screwdriver to secure the FlexIO. See (2) in Figure 5-21.
NOTE
A tool is required for this operation.
Step 9 Install the server. For details, see 4.4 Installing the Server on Guide Rails.
Step 10 Connect network cables to the FlexIO.
Step 11 Connect the power cables. For details, see 3.5 Connecting Cables to a PSU.
Step 12 Power on the server. For details, see 3.1 Powering On the Server.
Step 13 Log in to the iBMC WebUI, and check whether the new component is normal. For details, see
the TaiShan Rack Server iBMC User Guide.
----End
5.10 Rear Drive Module
5.10.1 2 x 3.5-inch Rear Drive Assembly
To install a rear drive module, perform the following steps:
Step 1 Wear an ESD wrist strap. For details, see 12 Preventing Electrostatic Discharge.
Step 2 Power off the server. For details, see 3.2 Powering Off the Server.
Step 3 Remove the power cables. For details, see 3.4 Removing Cables from a PSU.
TaiShan 2280 V2 Server
User Guide
5 Optional Part Installation
Issue 01 (2019-07-01) Copyright © Huawei Technologies Co., Ltd. 104
To Next Page
Loading...
