Step 4 Remove the server. For details, see 3.3 Removing the Server and Guide Rails.
Step 5 Remove the chassis cover. For details, see 3.6 Removing the Chassis Cover.
Step 6 Take a spare drive module out of its ESD bag.
Step 7 Install the rear drive assembly in the chassis and tighten the screws. See Figure 5-22.
NOTE
The procedure for installing rear drive assembly 1 is the same as that for installing rear drive assembly 2.
The following figure uses rear drive assembly 1 as an example.
Figure 5-22 Installing a rear drive assembly
Step 8 Determine the positions of the drives in the rear drive module. See Figure 5-23. Install all
drives in the drive module.
TaiShan 2280 V2 Server
User Guide
5 Optional Part Installation
Issue 01 (2019-07-01) Copyright © Huawei Technologies Co., Ltd. 105
To Next Page
Loading...
