Hypertherm XPR300 Replacement Part Procedures

Torch Connect Console
3
11 0 809970 Field Service Bulletin XPR300
8. Install the side panels.
9. Install the top panel.
10. Install the coolant. See the Coolant Installation section in the XPR300 Instruction Manual
(809480).
11 . Supply the gas pressure to the cutting system.

Hypertherm XPR300 Specifications

General

Cutting Current	300 A
Duty Cycle	100% at 300 A
Technology	X-Definition Plasma
Gas Supply	Oxygen, Nitrogen, Air
Cutting Capacity (Mild Steel)	38 mm (1.5 in)
Severance Capacity (Mild Steel)	75 mm (3 in)
Pierce Capacity (Mild Steel)	50 mm (2 in)
Input Voltage	200–480 V, 3-PH, 50/60 Hz