Hypertherm XPR300 - Replace a Solenoid Valve (V4-V10, V12)

Torch Connect Console
3
XPR300 Field Service Bulletin 809970 97
Replace a solenoid valve (V4-V10, V12)

See Torch connect console manifold side – view 2 on page 142 for
location and part number.
1. Complete the following procedures:
a. Remove the power from the cutting system.
b. Remove the gas pressure from the cutting system.
c. Remove the top panel.

See Torch connect console top panel and side panels on page 114.

Keep all nuts and screws that you remove.
2. Use the edge of the connector to disconnect the wire from the control PCB.

Be careful not to pull the wires out of the solenoid valve connector.