Hypertherm XPR300 - Page 96

Torch Connect Console
3
96 809970 Field Service Bulletin XPR300
5. Connect the wire connector.
6. Install the manifold-side panel.
7. Install the top panel.
8. Supply the gas pressure to the cutting
system.
9. Use the XPR web interface to make sure
that the pressures are in the acceptable
ranges.

For more information on the XPR
web interface, see the Connect
for Communication in the
XPR300 Instruction Manual (809480).
Transducer Connector
P3 J6
P1 J1
P14 J3
P4 J8
P5 J2
P2 J4
D58
D51
D41
D16
D84
D64
D35
D34
D75
D69
D87
D88
D24
D25
D