Hypertherm XPR300 Replacement Part Procedures

Gas Connect Consoles
2
XPR300 Field Service Bulletin 809970 79
7. Install the top panel.
8. Install the side panel.
9. Supply the gas and fluid pressure to the cutting system.
10. Use the XPR web interface to make sure that the pressures are in the acceptable ranges.

For more information on the XPR web interface, see the Connect for
Communication in the XPR300 Instruction Manual (809480).

Hypertherm XPR300 Specifications

General

Cutting Current	300 A
Duty Cycle	100% at 300 A
Technology	X-Definition Plasma
Gas Supply	Oxygen, Nitrogen, Air
Cutting Capacity (Mild Steel)	38 mm (1.5 in)
Severance Capacity (Mild Steel)	75 mm (3 in)
Pierce Capacity (Mild Steel)	50 mm (2 in)
Input Voltage	200–480 V, 3-PH, 50/60 Hz