Table 15. MAP 0190: Forms Feed Problems (continued)
Step Questions/Actions Yes No
2.
Examine the tractors for jammed or damaged forms.
Are the forms OK?
Go to step 3. Remove any jammed or
damaged forms.
You should investigate further to
find the root cause of the
jamming. Go to step 6 on
page 106.
3.
Check for paper debris, such as chad, stuck inside the
tractor jam sensors.
Are the sensors free of chad?
Go to step 4 on page 104. Wipe the sensors with a soft
cloth to remove the chad.
Remove the tractor and wipe the
upper and lower surfaces of the
sensor with antistatic liquid (IBM
P/N 2200118).
If you judge the amount of chad
to be excessive, advise the
customer to:
v Frequently clean out the chad.
v Ask the forms supplier to
reduce the chad.
Run T&D in automatic test mode
to verify correct printer operation.
For Model A00, see “How To Run
the Test and Diagnostic (T&D)
Programs” on page 161. For
Models 001, 002, or 003, see
“How To Run the Test and
Diagnostic (T&D) Programs” on
page 201.
Chapter 1. Diagnosing Problems
103
To Next Page
Loading...
Need help?
General