Table 15. MAP 0190: Forms Feed Problems (continued)
Step Questions/Actions Yes No
4.
Check for worn tractor jam sensors. Examine the plastic
surfaces of the sensor for signs of wear.
Are the sensor surfaces OK?
Go to step 5 on page 105. Replace the tractor assembly.
Run T&D in automatic test mode
to verify correct printer operation.
For Model A00, see “How To Run
the Test and Diagnostic (T&D)
Programs” on page 161. For
Models 001, 002, or 003, see
“How To Run the Test and
Diagnostic (T&D) Programs” on
page 201.
Chapter 1. Diagnosing Problems
104
To Next Page
Loading...
Need help?
General