Table 18. Error Messages for Models 001, 002, and 003 (continued)
Message Description Action
007 INCORRECT PRINT ORDER
PRESS STOP THEN START (Coax
interface only)
Invalid order received from host. Press Stop, then Start.
008 HOLD PRINT TIMEOUT
PRESS STOP THEN START
(Coax interface only)
Start key not pressed within 10 minutes of
pressing Stop.
Press Stop, then Start.
011 CHECK/LOAD BIN 1, 2, or 3
False message
Paper begins to feed from any bin, but
stops.
Forms path sensor cannot sense paper.
See “MAP 0131: Paper Path Sensor” on
page 66.
014 INVALID FORMS SELECT/FORM
NAME
SELECT NEW DEVICE
(Message and form name alternate on the
first line of the display)
Printer received a request for forms type
not supported in current forms
configuration.
Perform one of the following:
v Restart job.
v Cancel job.
v Select another source and restart the
job.
v Run the job with current source.
Refer to a 4247 User’s Guide for more
detail.
015 COMMUNICATIONS CHECK
CHECK CABLE
(Twinax interface only)
No line sync detected on the twinax
interface.
Error automatically resets when line sync is
detected.
See “MAP 0121: Parallel with Twinax or
Coax Attachments, Models 001, 002, or
003” on page 41.
017 COMMUNICATIONS CHECK
(Twinax interface only)
Line parity error detected. See “MAP 0121: Parallel with Twinax or
Coax Attachments, Models 001, 002, or
003” on page 41.
Chapter 1. Diagnosing Problems
137
To Next Page
Loading...
