IBM 4247

Table 18. Error Messages for Models 001, 002, and 003 (continued)
Message Description Action
032 FORMS JAMMED TIMEOUT
CLEAR JAM AND RELOAD FORMS
(Coax interface only)
002 FORMS JAMMED FRONT TRACTOR
or 020 FORMS JAMMED REAR
TRACTOR condition exceeded 60
seconds.
Jam detected at the front or rear tractor
jam sensor.
See “MAP 0190: Form Feed Problems” on
page 101.
033 TEAR PAPER TIMEOUT
TEAR OFF AT OUTPUT AND PRESS
PARK
(Coax interface only)
091 FANFOLD PARK condition exceeded
60 seconds.
1. Tear off paper after exit from the
printer.
2. Press Park to allow operation to
complete.
034 INVALID FORMS SELECT
TIMEOUT/FORMS NAME
SELECT NEW DEVICE
(Coax interface only)
(Message and form name alternate on the
first line of the display)
014 INVALID FORMS SELECT condition
exceeded 60 seconds.
Perform one of the following:
v Restart job.
v Cancel job.
v Select another source and restart the
job.
v Run the job with current source.
Refer to a 4247 User’s Guide for more
detail.
035 MARGIN ERROR TIMEOUT
ADJUST MARGIN OR LINE LENGTH
(Coax interface only)
005 MARGIN ERROR condition exceeded
60 seconds.
Press Stop, then Start. Left margin value
will be reset to 10 for current line only.
036 TEAR PAPER TIMEOUT
TEAR OFF AT INPUT AND PRESS EJECT
(Coax interface only)
092 FANFOLD EJECT condition exceeded
60 seconds.
Tear off paper before entering the printer
and press Eject to allow operation to
complete.
Chapter 1. Diagnosing Problems
139