Table 18. Error Messages for Models 001, 002, and 003 (continued)
Message Description Action
098 HOLD PRINT TIMEOUT
PRESS LOAD
(Coax interface only)
003 FORMS EJECTED condition exceeded
60 seconds.
Press Load.
099 FORMS JAMMED
CLEAR JAM THEN PRESS START
(ASF paper path)
Paper still present after attempted Park or
Eject.
See “MAP 0110: Automatic Sheet Feeder”
on page 26.
099 FORMS JAMMED
CLEAR JAM THEN PRESS START
(All other paper paths)
Path sensor sensed paper still present
after attempted Park or Eject. For fanfold
forms, this message can display if you park
but do not tear off the output.
Path sensor detected forms already
present when you tried to load forms into a
fanfold path.
1. Ensure fanfold forms are torn off
before parking the forms.
2. Ensure fanfold forms are loaded onto
the tractor pins, with the leading edge
visible on the tractor.
3. Check for pieces of paper in the
manual sheet feed, under the platen,
and above the front tractor.
4. If message remains, see “MAP 0190:
Form Feed Problems” on page 101.
200 ATTACHMENT INCOMPATIBLE
MODEL 003
SEE USER’S GUIDE
Installed attachment card is not compatible
with the printer base code loaded.
The coax attachment card is missing,
install a coax card.
Printer base code must be reloaded for the
installed attachment card, see Appendix C.
Flashing the Memory of the Model 003, or
change the attachment card to the correct
type. See Model 003 Attachment Cards:
Serial, Twinax, LAN, Coax. For details
about base code compatibility, see
Reference Table 9, Base Code
Compatibilities.
Chapter 1. Diagnosing Problems
143
To Next Page
Loading...
