18. Press any key to feed the paper back into the printer and the following message will display:
YES<- STORE ->NO
If the first print-line adjustment is correct, press the Micro ↑ key to store the first print-line position. Continue with
step 21.
-or-
If the first print-line adjustment is not correct, press the Load/Form Feed key to view the next display:
+ F.RE XXX -
19. To move the first print-line closer to the top of the paper, press the Load/Form Feed key.
To move the first print-line down away from the top of the paper, press the Micro ↑ key.
The range is -128 to +127. Each unit is approximately 0.2 mm.
20. Press the Micro ↓ key to print using the new adjustment value. See step 16.
21. If an error message is displayed, go to “T&D Error Messages and Actions” on page 190.
22. The test completed successfully if the display advances to the next test number.
T&D16 - Bidirectional Adjustment Test
This test allows you to make the bidirectional adjustment from the operator panel.
If the following message displays, go to “T&D11 - Pinch Roller Status/Sensor Tuning/Ribbon Feed and Lift Motors”
on page 168.
PINCH XXXXX
Note: XXXXX is CLOSE or OPEN.
Return here after the sensors are tuned.
Chapter 2. Diagnostics 178
To Next Page
Loading...
Need help?
General