Chapter 19. Microsoft Cluster configuration with DS3500 583
Draft Document for Review March 28, 2011 12:24 pm Microsoft Cluster configuration with DS3500.fm
Figure 19-12 Installation Succeeded
19.4.2 Validate a Configuration
Before creating a cluster, we strongly recommend that you validate your configuration.
Validation helps you confirm that the configuration of your servers, network, and storage
meets a set of specific requirements for failover clusters.
To validate the failover cluster configuration
1. To open the failover cluster snap-in, click Start, click Administrative Tools, and then click
Failover Cluster Management as shown in Figure 19-13 on page 584
To Next Page
Loading...
