Chapter 20. SuSE Linux configuration guide 619
Draft Document for Review March 28, 2011 12:24 pm Linux Config.fm
Figure 20-16 Press Enter key to install the necessary packages
3. The initiator name is automatically generated by SuSE. This is the Initiator name that
Storage Manager will discover. Select the option When booting to start automatically the
service. The window should be similar as shown in Figure 20-17.
Figure 20-17 Select When Booting
4. Map the logical drive to the server using the procedure documented in Chapter 11,
âAdministration - Mappings Tabâ on page 281.
5. While its possible to discover all the targets, by discovering only the first address of iSCSI
host port, we will type each ip address manually in Connected targets tab. We will
demonstrate the other procedure to configure it manually by using the command line on
20.2.3, âConfiguring iSCSI software initiator manuallyâ on page 624. Select Connected
To Next Page
Loading...
