Creating a User Waypoint by Radial/Distance (continued)
11. Turn the Small knob to display the
desired character. Turn the Large knob to
make the next character you want to
change flash. Repeat as necessary to edit
the identifier, latitude, longitude, and
the runway length. The identifier may
contain a maximum of six characters.
ALSEA USER
44°23.72N RWLEN
124°04.21W 1000
DB
12. Press ENT to store the waypoint in
memory.
CREATE USER WPT
BY RADIAN/DIST
PRESS ENT
DB
If a duplicate identifier is entered, the
display below appears for
approximately 3 seconds. The NMC
then displays the waypoint editing page
so you can change the identifier.
DUPLICATE USER
WAYPOINT IDENT
NOT ALLOWED
DB
134
DB Mode Procedures Operations
ENT
To Next Page
Loading...
