Between EAT and FF285 (Point B)
with a heading of 105°, press
OBS/HLD to suspend sequencing.
3. Press DIRECT-TO twice. Select an
OBS setting of 285° with the Large
and Small knobs and then press ENT
to select an inbound course. Note that
the CDI will be “reverse-sensing” just
as it would when outbound from a
VOR with the OBS set to the inbound
course. (Point C)
9. At point D, make the procedure turn.
10. At the intercept of the inbound course
to the FAF, press OBS/HLD to allow
sequencing at the FAF. Waypoint
FF285 now becomes the FAF. (Point E)
245
Operations Approach Procedures
ENT
D
D
To Next Page
Loading...
