Illustration Points
A - Between EMETT (IAF) and PARMO (APPR)
B - Between PARMO (APPR) and DEFKI (FAF)
C - Between DEFKI (FAF) and RW11 (MAP)
D - Between RW11 (MAP) and NEMEW (MAHP)
E - In Holding Pattern
En Route
Load and activate your flight plan, then load the approach. Select the
Nampa Municipal GPS Rwy 11 approach.
30 nm From Nampa Municipal Airport
1. The message annunciator will flash. Press MSG and then ENTER
to enable the approach.
2. Select the local Altimeter Setting with the SMALL knob and then
press ENTER. Press NAV to return to NAV mode.
Point A (Between EMETT and PARMO)
1. Fly the segment.
2. Verify that the Approach annunciator is on.
Point B (Between PARMO and DEFKI)
1. Fly the segment.
2. The Approach Active annunciator will begin flashing 3 nm from
DEFKI (FAF) indicating that approach RAIM prediction is
beginning. The transition to approach active is starting.
3. At 2 nm from DEFKI the CDI scale will begin changing from 1 nm
to 0.3 nm full scale deflection.
Point C (Between DEFKI and RW 11)
As you cross DEFKI, verify that the Approach Active and OBS/HLD
annunciators are on steady.
278
To Next Page
Loading...
