Point F (Choosing not to land at the MAP)
1. At the Missed Approach Point, if you are not going to land, follow
your missed approach clearance. The MAP will remain active and
your Apollo NMS will continue to provide guidance on the final
approach course until you press the OBS/HLD button. If you
choose to not land, the published missed approach instructions say
“climbing right turn to 6100’ direct OED VOR and hold.” You will
then press the OBS/HLD button as soon as you decide to miss the
approach.
2. The CDI will scale out to 1 nm and OED will become the active
waypoint. As you reach 6100’, press DIRECT-TO and then press
ENT to establish a direct route to the active waypoint (OED).
3. Because OED is the MAHP, it is automatically a Hold waypoint and
flight plan sequencing is suspended. Verify that the OBS/HLD
annunciator is lighted.
Point G (At the MAHP)
1. Upon crossing OED, select the inbound holding course (153°). Press
DIRECT-TO twice. Use the Large and Small knobs to select 153°.
Then, press ENT.
OBS DTK: 153°
TO OED
BRG 162 DTK 162
2. After selecting 153° inbound, enter the Hold waypoint as you would
for a VOR with 153° selected on the OBS.
285
To Next Page
Loading...
