2.FlyasyouwouldwithaVORwith“162° TO”selectedontheOBS.
Point D (Inbound to OED)
1. As you intercept the 162 inbound re-enable flight plan sequencing.
Press OBS/HLD as soon as you enable sequencing, OED becomes
the FAF. At 3 nm inbound to OED, the Approach Active
annunciator will begin flashing to indicate an impending CDI
sensitivity change.
2. At 2 nm inbound to OED, the CDI sensitivity will begin changing
from 1 nm to 0.3 nm full-scale deflection.
3. As you cross OED, the Approach Active annunciator will come on
solid to indicate that approach operation is active and you may
continue the approach to the FAF.
Point E (Between OED and MA14)
1. Continue to the missed approach point. Verify that the OBS/HLD
and Approach Active annunciators are lighted steady.
2. If you wish to cancel Approach Active, press OBS/HLD. Your
Apollo NMS will then revert to Approach Transitionwith 1 nmCDI
deflection anda1nmRAIM alarm limit.
284
To Next Page
Loading...
