Emergency Mode Displays (continued)
The display below may be selected with the Large knob after entering
EMG mode, and is used to set the runway search limits. The surface
limit may be set for “Hard”, “Hard/Soft”, or “Hard/Soft/Water”.
Lighting requirements (“LIT:”) may be set for “YES” or “NO”. The
runway requirements may be changed by pressing SEL, using the
Large and Small knobs to edit the display, and pressing ENT. Those
waypoints that do not meet the requirements are not displayed while
using the Emergency Search or Search Around a Waypoint features.
All nearest waypoints are displayed during Emergency Search if
runway limits are set to zero.
RUNWAY LIMITS
HARD/SOFT/WATER
FT:1200 LIT:YES
If you attempt to set the lighting requirement when the runway length
is set at 0, the display below appears for approximately 3 seconds.
ZERO RWY LENGTH
CANNOT EDIT
LIGHTING
If you attempt to set the surface type requirement when the runway
length is set at 0, the display below appears for approximately 3
seconds.
ZERO RWY LENGTH
CANNOT EDIT
SURFACE TYPE
29
Operations Emergency Mode Displays
To Next Page
Loading...
