Auto OBS Crossing Holding Waypoint
When a waypoint on hold is crossed to the FROM side the first time, the
NMC will generate the following message. Note: This message is not
generated when crossing the MAP. If you press ENT, the OBS Desired
Track screen is displayed. If you press NAV, the NAV page is displayed.
This message does not become an old message after viewing.
Push ENT To Set
OBS Course
or NAV To Exit
User Database Memory Corrupted Message
The display below shows the memory storing one or more User
waypoints or comments is corrupted, and memory was deleted. The
NMC tests all User waypoints each time the unit is turned on. In the
example below, 3 User waypoints or comments were deleted. This
message clears after it is viewed.
User Database
Memory Loss
3 Deleted
Flight Plan Memory Corrupted Message
The display below shows the memory storing one or more flight plans
is corrupted, and the affected flight plans were deleted. The NMC tests
all flight plans each time the unit is turned on. In the example below, 2
flight plans were deleted. This message clears after it is viewed.
Flight Plan
Memory Loss
2 Deleted
User Setups Memory Corrupted Message
The display below shows the memory storing user configuration
settings such as SUA Buffers or the Flight Timer Trigger Speed is
corrupted, and settings have been restored to default (factory) values.
This message clears after it is viewed.
Memory Failure
User Setups Have
Been Reset
54
Message Displays Operations
To Next Page
Loading...
