4 - 37
4.3.7.2 Change of Auxiliary Information
Change the settings of display/non-display of ‘Test beginning/ending time’ and peak mark
on the tab of ’Aux. information’ tab.
After completing necessary changing, press the button of [OK].
4.3.7.2.1 Test Beginning/Ending Time
Whether test beginning/ending time should be displayed in the legend window or not can
be set.
While a test is being executed, test beginning time is displayed when excitation is started,
and test ending time is displayed when the excitation is ended.
This setting is valid for applications shown below.
SINE, RANDOM, SHOCK, RESONANCE DWELL, Multi-SWEEP SINE
BMAC, Multi-RANDOM, Multi-SINE, BMAC with Torsion
Note) There may be some differences between the time displayed and that of the
execution status and history.
Whether beginning/ending time should be displayed
in the legend window or not can be set.
Peak mark setting is available.
Whether automatic adjustment of legend
length should be available or not can be set.
To Next Page
Loading...