IMV K2 - Startup and Stopping of System

2 - 40
2.6 Startup and Stopping of System
General system operating procedures are shown below.
2.6.1 Startup of System
＜Procedures＞
＜Step 1＞
After checking that the power supply to the I/O Unit and the power amplifier is not turned on,
turn on the power supply to the PC, and then, start up the Windows.
＜Step 2＞
After turning on the power supply to the K2 I/O Unit, turn on the power supply to the power
amplifier.
＜Step 3＞
Start up the application. For the procedures of application startup, refer to “4.2.1 Application
Start UP” in Chapter 4.
2.6.2 Stopping of System
＜Procedures＞
＜Step 1＞
Finish the application. To finish the application, refer to “4.2.2 Exit from Application” in
Chapter 4.
＜Step 2＞
After turning off the power supply to the power amplifier, turn off the power supply to the K2 I/O
Unit.
＜Step 3＞
Finish the Windows, and then, turn off the power supply to the PC.