IMV K2 - This Section Is Left Blank Intentionally.)

5 - 3
SOR
(*1)
Below buttons in the Manual operation tool bar are grayed out (invalidated):
“Excitation level up”, “Excitation level down”, “Excitation level change”,
SOR Sine “ON”, “OFF”,
“Shift to the beginning of the next sweep”, “Sweep reverse”,
“Sweep hold”, “Sweep hold cancel”
ROR
(*1)
Below buttons in the Manual operation tool bar are grayed out (invalidated):
“Excitation level up”, “Excitation level down”, “Excitation level change”,
ROR Narrow band Random “ON”, “OFF”,
“Shift to the beginning of the next sweep”, “Sweep reverse”,
“Sweep hold”, “Sweep hold cancel”
(*1) If the initial excitation level is specified to under 0dB, there is no constraints in operation.
But a part of E-save functionality or whole functionality becomes invalid.
・Air-cooled systems：Blower control only
・Water-cooled systems：E-save functionality is invalid
5.3 (This section is left blank intentionally.)
E-save mode
E-save mode