IMV K2 - Chapter 7 Launcher; Outline

7 - 1
Chapter 7 Launcher
7.1 Outline
Launcher is the software to start up the K2 application (application software) including SINE. Though
the Launcher is the standard attached software, partial functions are optional.
Launcher has the three modes shown below.
1) ‘Applications’ mode
2) ‘Standards’ mode
3) ‘Test files’ mode
Note) ’Standards’ mode and ‘Test files’ mode need standard options.
1) ‘Applications’ mode
K2 applications including SINE can be simply started.
2) ‘Standards’ mode (standard options are needed)
In this mode, test conditions can be selected in the list of standards such as ISO, and test can be
executed without detailed test definition.
Operation procedures are as follows: ‘Selecting standards’→’Test reference check’→’Test file
saving’. When ‘Test file saving’ is executed, application is automatically started, and the hardware is
initialized, and shifted to the status of waiting for excitation.
Application and test types applicable to this mode are as shown below.
Application Test type
SINE SINE SWEEP[sweep test](*.swp2) / SINE SPOT[spot test](*.spt2)
RANDOM RANDOM[random](*.ran2) / SOR(*.sor2) / ROR(*.ror2)
SHOCK SHOCK(*.sho2) / SRS SHOCK(*.srs2)
Multi-Sweep Sine
MSS FREQ[frequency division sweep](*.fds2) /
MSS TIME[delay sweep](*.tis2) / MSS SPOT[multi spot](*.msp2)
3) ‘Test files’ mode (Standard option is required)
This mode allows the selection of existing test files to execute test.
Operation procedures are as follows: ‘Test file selection’→’Test reference check’→’Test file
saving’.
When ‘Test file saving’ is executed, application is automatically started, and the hardware is
initialized, and shifted to the status of waiting for excitation.
Application and test types applicable to this mode are the same as those of the ‘Standards’ mode.