IMV K2 - Page 6

3.3.1 Excitation System Information name .......................................... 3-2
3.3.2 Drive Output ................................................................ 3-2
3.3.3 Polarity.................................................................... 3-2
3.3.4 Initial Output Voltage Default Value ........................................ 3-3
3.3.5 Rating Information .......................................................... 3-3
3.3.5.1 Load from system model................................................ 3-3
3.3.6 Control Frequency Range is limited .......................................... 3-3
3.3.7 Other Control Quantities .................................................... 3-3
3.3.8 Contact I/O ................................................................. 3-3
3.3.9 Armature mass ............................................................... 3-4
3.4 Input Channel Information ......................................................... 3-5
3.4.1 Input Environment Information Name .......................................... 3-5
3.4.2 Name (Channel Name) ......................................................... 3-5
3.4.3 Module / Ch. ................................................................ 3-6
3.4.4 Quantities .................................................................. 3-6
3.4.5 Input Type .................................................................. 3-6
3.4.6 Sensitivity ................................................................. 3-6
3.4.7 Polarity.................................................................... 3-7
3.4.8 TEDS Access ................................................................. 3-7
Chapter 4 Fundamental Operation Method ................................................... 4-1
4.1 Outline ........................................................................... 4-1
4.2 Fundamental Operation ............................................................. 4-2
4.2.1 Application Start Up ........................................................ 4-2
4.2.2 Exit from Application ....................................................... 4-3
4.2.3 Description of Icons ........................................................ 4-5
4.2.4 File Operation .............................................................. 4-8
4.2.4.1 File Open............................................................. 4-8
4.2.4.2 Save As............................................................... 4-9
4.2.5 Add a Page .................................................................. 4-10
4.2.6 Palette Operation ........................................................... 4-12
4.2.6.1 Palette Tool Icons.................................................... 4-12
4.2.6.2 Moving the Palette.................................................... 4-13
4.2.7 Other Operations ............................................................ 4-14
4.2.7.1 Set Up................................................................ 4-14
4.2.7.2 Operation Status...................................................... 4-15
4.2.7.3 Manual Operation...................................................... 4-15
4.3 Graph Operation ................................................................... 4-16
4.3.1 Graph Tool Icons ............................................................ 4-16
4.3.2 Selecting of Graph Display .................................................. 4-17
4.3.2.1 Selecting of 3D graph................................................. 4-19