Affinity
2.0
Additional Information Page 167
• HA1 – Mold refers using an RECD measured using the client’s own ear mold followed by 2cc coupler
measures with an ITE adaptor.
• HA1 – Tip refers using an RECD measured using a foam tip or SPL probe followed by 2cc coupler
measures with an ITE adaptor.
• HA2 – Mold refers using an RECD measured using the client’s own ear mold followed by 2cc coupler
measures with a BTE adaptor.
• HA2 – Tip refers using an RECD measured using a foam tip or SPL probe followed by 2cc coupler
measures with a BTE adaptor (the insert foam tip connects to the in-situ headset the same way as
described for HA2 – Mold above).
Note: Remember to indicate the correct coupler type before performing the RECD based 2 cc coupler
measures.
(For more information about the DSL mi/o v5.0a please refer to www.dslio.com
) s
To Next Page
