Interacoustics affinity 2.0 - Combined Screen Setup

Affinity
2.0
Additional Information Page 321
3.8.3 Combined Screen Setup
HIT440 can be setup for default curve comparisons. This is done in the Setup combined screen menu.
1) To enter the Setup combined screen menu, select your test protocol in the Selected protocol
dropdown list in the main setup.
2) Click on the Setup combined screen button.
This will prompt the combined screen setup below:
3) To create a default curve comparison view, click on Add new screen. A tab will then appear in the
upper part of the screen.
4) Use the arrows to move the measurements to be compared (listed to left) to the new screen. If
preferred you can add several new comparison screens.
5) When finished click OK to return to the main setup.
4