Affinity
2.0
Additional Information Page 322
Note: Before closing the setup remember to tick the Display combined screen check box for the
combined screen settings to be active.
When a combined screen view is setup you can click on the Toggle between single and combined
screen button in the front screen to view the desired curves together:
If no combined screen view is setup Toggle between single and combined screen will show all
measured curves.
3.8.4 Print Layout Settings
The HIT440 module allows for setting up individual print layouts. This is done in the Print Wizard which is
entered using the Print Wizard button (read about the Print Wizard in section 4.1).
To Next Page
Loading...
Need help?
General
