Interacoustics affinity 2.0 - Reference Test Gain Settings

Affinity
2.0
Additional Information Page 312
3.8.2.9 Reference Test Gain Settings
1) Ensure that Reference Test Gain is marked in the left hand side of the screen. The name of the test
will then appear in the Name of selected test section. Note the option to write a new name for the
test in this section (e.g. “Equiv. Input Noise 60 dB input”)
2) Stimulus Selection:
 Input Level: Set the input level using the slider.
 Stimulus type: Select a stimulus using the dropdown list (Note that only Pure Tone and Warble
Tone are available).
3) Reference Frequency:
 Ref f: Tick this option to select a single reference frequency using the slider. After measuring
the curve the level at the reference frequency will be displayed in the measurement details
table.
2
3
4
1