Affinity
2.0
Additional Information Page 184
There are two ways to measure RECD which will be described in this section:
a) RECD with the client’s own ear mould
b) RECD with an SPL probe
Right click on the RECD test in the protocol list and select Settings to check if the system is setup to use the
client’s own ear mould or SPL probe for the RECD.
To use the SPL probe tick Use insitu SPL probe. If this box is not ticked the system will assume that you are
using the client’s own ear mold.
Click the box to use
the SPL Probe
To Next Page
Loading...
