www.javad.com Maxor Operator’s Manual 2-43
CONFIGURATION
Bluetooth® Module Configuration
• Encryption – enable to have the Bluetooth® module encrypt wirelessly
sent data. To read encrypted data, the user must have the same PIN used in
the device that sent the data.
• Authentication – enable to require a PIN before two Bluetooth
® enabled
devices (such as, the receiver and a computer) can establish a
communication link. The two devices must use the same PIN.
Notice
If you do not need security settings, leave these
parameters disabled.
Figure 2-34. BTCONF Security Parameters
9. Click the Serial Interface tab (Figure 2-35). Enable Echo to display
Bluetooth® module replies and corresponding commands on the computer
terminal. If needed, cl
ick Apply.
Figure 2-35. BTCONF Serial Interface Tab
10. Click Disconnect then Exit to quit BTCONF.
To Next Page
Loading...
