8
▋▋Throttle▋stroke▋travel▋adjustment
By adding the Throttle stroke adjustment plate to the gimbal, the throttle stroke is limited by approximately 5
degrees.
Be sure to install or remove the plate with reference to the drawing.
When adding this "limiter plate" it is essential to recalibrate the throttle stick range. Be sure to follow this
procedure.
Note:
RefertothePage76"TransmitterSetting【TXSETTING】"
in the system list for further details of calibration.
▋Handling▋of▋the▋Rechargeable▋Ni-MH▋batteries▋used▋
for▋the▋Receiver
Because nickel metal hydride batteries have a high self-discharge rate, battery discharge will gradually take
place even when the battery is not being used.
For new batteries and batteries that have not been used for a long time, be certain to fully charge before use.
In addition, if the battery is repeatedly charged having not been fully discharged, the battery chemistry
characteristics may mean that the discharge capacity becomes temporarily reduced, because of a ‘memory
eect’. It is therefore recommended you occasionally fully discharge the battery and then recharge it before
use.
Charging at very high and low temperatures is dangerous.
Charging nickel metal hydride batteries at high temperatures will cause a noticeable drop in charge capacity.
Therefore, do not charge in a hot environment, for example inside a car. Hydrogen gas may be generated
during charge and discharge - avoid charging close to any open ame.
To Next Page
Loading...
Need help?
General
