36
▋Throttle▋trim【THRO▋TRIM】
▋▋Function▋Explanation
This function sets the Throttle Trim movement, and additionally a Throttle Cut function is
provided for cutting the engine. There is a Trim Memory function for cutting the engine using
the Trim. Note that for airplanes, an Idle Adjust function is also incorporated that allows
separate detailed setting of the idle position.
▋▋Setting▋Method
If the Throttle Cut is set to ACT, the Trim Memory will be forcibly set to INH. On the screen rotate the dial to
move to and select (inverse display), then press the dial to set the item.
Throttle Cut Function (THRO CUT)
The Throttle cut can be used by setting it to “ACT”. Initially the switch is allocated to “TRN SW”, POS1. It is
possible to allocate this switch to any desired switch location. Set the Throttle Cut to the desired position.
፧
Time Lag (TIME LAG)
This function is to avoid the sudden stopping of the engine if the throttle cut switch is activated in error.
This is especially useful when using the momentary switch (Trainer switch). It is possible to use this
momentary switch as timer switch at the same time as throttle cut. When the time lag function is activated,
throttle cut only activates when the switch is held on for a certain duration. The timer can be activated by
a momentary action as usual. The time lag duration can be set between 0.5 to 2 seconds.
Throttle Trim Memory (THRO TRIM MEMORY)
When the Trim is lowered in a single action, the trim position immediately prior to the movement will be
memorized, and when the trim is raised again, the trim will automatically return to the memorized position.
The memorized position will be marked on the Trim display.
Idle Adjust (IDLE ADJUST)
※ For Airplane Mode only
The idle position when the throttle
stick is at the “Slow” position can be
given a separate setting using a switch.
It is possible to set up landing with idle
“DOWN”, and normal flying with idle
“UP”.
Please carefully conrm the linkage does not jam when the carburetor is closed.
▋▋Caution▋Note
Throttle Cut will only work when the helicopter Flight Mode is set to “NORMAL”.
Helicopter
Airplane
In order to use the function,
INH should be changed to ACT
In order to use the function, after setting
the Throttle Cut function to INH, set the
Trim Memory to ACT in this function.
In order to use the function,
INH should be changed to ACT
In order to use the function, after setting
the Throttle Cut function to INH, set the
Trim Memory to ACT in this function.