50
▋Motor▋System【MOTOR▋SYSTEM】
▋▋Function▋Explanation
This function is used to switch o (HOLD) the motor channel by using the Gear switch (default)
or by selecting various ight mode positions. By using the Delay function, it is possible to smoothly run the
motor from low r.p.m. to higher r.p.m. in a linear transition (Note: The speed controller must have a linear
transition to activate this function).
▋▋Setting▋Method
In order to activate this function, it is necessary to set the “GEAR” channel or “AUX3” channel as “MOTO ”
under the System List.
Hold Delay (HOLD DELAY)
UPPER ARROW (↑) : Delay time before switching on the motor.
DOWN ARROW (↓) : Delay time before switching o the motor.
▋▋Caution▋Note
Be sure to set the “WARNING” function under the system list and be aware of the motor starting unexpectedly.
It is very easy to accidently turn on a switch and the motor start, and not immediately realize why.
Set the speed controller to run the motor and carefully conrm the settings before ying.