34
▋Governor【GOVERNOR】
▋▋Function▋Explanation
A governor maintains the rotor rotation speed at a uniform value. This function sets the
rotation speed of the Governor to aid in stable ight. Dierent rpm settings can be made separately for each
Flight Mode.
▋▋Setting▋Method
If the output “OUT” of an auxiliary channel is not set to “GOV” before using the function, the display in the
Function List will be shown as non-usable. In addition, a Trim Input switch function can also be used. On the
screen, set the rotor rotation speeds for each Flight Mode. Select the desired Flight Mode by rotating the dial,
then press the dial to display the box for numerical value adjustment. Note that because the setting from the
transmitter is a numeric adjustment, the actual rotation speed should be set and conrmed by the governor.
Trim Input Function (TRIM IN)
By using the Trim Input, it is possible to change the governor sensitivity values using a Trim Lever. Therefore,
it is easy to adjust the rpm during ight.
By using the Trim Input, it will be possible to change the gyro sensitivity values using the Trim Lever.
Therefore, it will be possible to easily adjust the sensitivity even during ight.
▋▋Caution▋Note
Be sure to understand your Governor manual thoroughly to allow you to use this function correctly.
To Next Page
Loading...
Need help?
General
