73
▋Trim▋input▋Switch【TRIM▋INPUT▋SWITCH】
▋▋Function▋Explanation
This function allows adjustment of Mixing values or the Sensitivity value for Gyro settings,
using a chosen trim lever. It is a very useful function which enables ne tuning during ight.
▋▋Setting▋Method
There are four types of Trim Input switch. The Initial setting of the Trim Lever is “THRO TRIM”
(Note: For Gliders it is “SPOI TRIM”). There is no option for using a Trim Input Switch for “SW
SEL”. For each Trim switch, select which Trim Lever will be used to operate it. Then select which
switches are to be used to turn the Trim Input function On and O.
調整ポイント表示
ポイント接続を曲線に変更 スティック入力位置と出力位置の数値表示
現在の
フライトモード位置
各調整ポイントの
入力位置と出力位置
ポイントの
追加と削除
注意:
グラフはホバリン
グスロットルやス
ロットルトリムで
変化する場合もあ
ります。
カーブをコピー
Trim Input Switches have dierent uses depend on each model type. Also note the functionality of the four
types has to be selected before activating the Trim Input.
ForHelicopter
፧
Gyro sensitivity (GYRO SENS) ・・・・ Change Gyro Sensitivity.
፧
Governor (GOVERNOR) ・・・・・・・ Change Rotor r.p.m..
ForAirplane
፧
Flap System (FLAP SYSTEM) ・・・・ Change the Flap position.
፧
Dierential (DIFFERENTIAL) ・・・・ Change the amount of Dierential.
፧
Gyro Sensitivity (GYRO SENS) ・・・・ Change the gyro Sensitivity.
ForGlider
፧
Brake System (BRAKE SYSTEM) ・・・ At Point “0” (Maximum amount of Braking) Change the Mixing
amount.
▋▋Caution▋Note
Actually operate the servos and carefully conrm the settings before ying.
When a Trim input switch is activated the Normal Function of the Trim is inhibited.
Helicopter
Airplane
This selects the switches for switching ON/OFF this function
This selects the Trim Lever
that enables setting by the
numerical values
Switch ON/OFF Condition Display