To Next Page

To Previous Page

106

▋Software▋Error▋Screens

▋▋If▋the▋Following▋Messages▋are▋Displayed...

If errors occur in transmitter software operation, error displays are shown to indicate the internal error details.

▋▋Model▋Data▋Reading▋Failure

⿟ Cause

This is displayed if the model data is initialized, and when there are internal memory operation problems.

⿟ Response

If the message is repeatedly displayed, please contact this company’s Service Department.

▋▋This▋is▋displayed▋when▋the▋model▋setting▋data▋has▋not▋been▋normally▋saved.

⿟ Cause

This is displayed if the battery is removed while setting is taking place, and when there are problems in the

internal memory.

⿟ Response

If the message is repeatedly displayed, please contact this company’s Service Department.

When▋Required...

Operation Manual1
Introduction3
Greetings3
Features3
General・Safety・Precautions4
Table of Contents6
Contents6
Switch・Identification・Stickers7
Stick・Length・Adjustment7
Neck・Strap・Attachment7
Inserting・And・Removing・The・Sd・Card7
Preparation7
Inserting・And・Removing・The・Transmitter・Battery8
Charging・The・Transmitter・Battery8
Notes・On・Stick・Tension・Spring・Adjustment・And・The・ Throttle・Stroke・Travel・Adjustment・Plate9
Handling・Of・The・Rechargeable・Ni-Mh・Batteries・Used・For・ The・Receiver10
Receiver・Connections11
Using・The・Transmitter・And・Receiver12
Receiver・Mounting・Location12
Binding・Procedure14
(Pairing・The・Transmitter・And・Receiver)14
Names・Of・Each・Transmitter・Control15
Functions▋Common▋To▋All▋Models15
Names・And・Functions・Of・The・Input・Keys17
Initial・Info・Screen18
My・List・Screen19
Navigation・During・Model・Setting20
Flight・Mode21
Dual-Rate・&・Exponential 【D/R&Exp23
Function▋List23
Travel▋Adjust 【TRAVEL▋ADJUST24
Limit▋Adjust 【LIMIT▋ADJUST25
Sub・Trim 【SUB・TRIM26
Reverse・Switch 【REVERSE・SW27
Servo・Speed 【SERVO・SPEED28
Throttle・Curve 【THRO・CURVE29
Pitch・Curve 【PITCH・CURVE31
Tail・Curve 【TAIL・CURVE32
Throttle・Hold 【THRO・HOLD33
Gyro・Sensitivity 【GYRO・SENS34
Governor 【 GOVERNOR36
Swash・Mixing 【SWASH・MIX37
Throttle・Trim 【THRO・TRIM38
Throttle・Mixing 【MIX → THRO39
Flight・Mode・Delay 【FLIGHT・MODE・DELAY40
Flap・System 【Flap・System41
Snap・Roll 【Snap・Roll42
Differential 【 DIFFERENTIAL43
Aileron・To・Rudder・Mixing 【AILE → RUDD・MIX45
Aileron・To・Flap・Mixing・【AILE → FLAP・MIX46
Elevator・To・Flap・Mixing 【ELEV → FLAP・MIX47
Rudder・To・Aileron・/Elevator・Mixing48
Rudd → Aile/Elev・MIX48
Balance 【BALANCE49
Flap・Rate 【FLAP・RATE51
Motor・System 【MOTOR・SYSTEM52
Camber・Sytem 【CAMBER・SYSTEM53
Brake・System 【BRAKE・SYSTEM54
Flaperon・Mixing 【FLAPERON・MIX55
Elevator・To・Camber・Mixing56
Elev → Camb・MIX56
Rudd → Spoi・MIX57
Rudder・To・Spoiler・Mixing57
Program・Mixing 【PROGRAM・MIX・1-658
Timer 【Timer63
Mixing・Monitor 【MIX・Monitor64
Servo・Monitor 【Monitor65
Model・Select 【Model・Select66
System▋List66
Model・Copy・&・Erase 【Model・Copy/Erase67
Model▋Type▋Select 【TYPE▋SELECT69
Model・Name 【MODEL・NAME70
Flight・Mode・Name 【FLIGHT・MODE・NAME71
Trim・System 【TRIM・SYSTEM72
Stick・Position・Switch・【STICK・POSITION・SW74
Trim・Input・Switch 【TRIM・INPUT・SWITCH75
Stick▋Alert 【STICK▋ALERT76
Warning 【WARNING77
Transmitter・Setting 【TX・SETTING78
Trainer 【 Trainer】Aka:・Buddy・Box・In・The・Usa79
Bind・And・Range・Check 【BIND&RANGE80
Telemetry・System 【TELEMETRY81
All・Servos・Hold 【ALL・SERVOS・HOLD84
Device▋Select 【DEVICE▋SELECT85
Swash・Type 【SWASH・TYPE88
Wing・Type 【WING・TYPE89
Fail・Safe 【FAIL・SAFE91
Throttle・Stick・Direction92
Thro・(Spoi)・Stick・Direction92
Stick・Mode 【STICK・MODE93
Xbus・Function 【X.BUS94
Xg14・Data・Sheet・・/・・Heli96
Data▋Sheet96
Xg14・Data・Sheet・・/・・Acro100
Xg14・Data・Sheet・・/・・Glid104
Software・Error・Screens108
When▋Required108
Repair・And・After・Sales・Service109

Brand	JR
Model	XG 14
Category	Remote Control
Language	English

JR XG 14 User Manual

Table of Contents

Questions and Answers:

JR XG 14 Specifications

Related product manuals