26
▋Servo▋Speed【SERVO▋SPEED▋】
▋▋Function▋Explanation
This function slows down the operation speed of the servos independently for each channel.
This function should be considered as a speed limiter. The speed setting can be set separately
for left/right (up/down). Additionally, the setting can be set to ON or OFF in each Flight Mode,
or controlled using optional switches. Further, this function can be turned ON or OFF using a
desired throttle stick position (not available for gliders).
▋▋Setting▋Method
Rotate the dial to move the inverse display area and select the channel, then press the dial to
display the setting box, and carry out the speed setting.
“NORM” is the fastest setting, and the speed can be slowed between 0.1-15.0 seconds. This
indicates the time that the servo takes to rotate through 60 degrees. Note there may be some
slight variation depending on the servos used.
Depending on the application, some channels may not be able to have a speed set, and “----“ will be displayed.
▋▋Caution▋Note
When the servo speed has been set, carefully conrm the servo speeds using actual switch operation before
ying.
To Next Page
Loading...
Need help?
General
