JR XG 14 - Rudder・To・Aileron・;Elevator・Mixing; Rudd → Aile;Elev・MIX

46
▋Rudder▋to▋Aileron▋/Elevator▋Mixing▋
【RUDD → AILE/ELEV▋MIX】
▋▋Function▋Explanation
This function mixes Rudder operation to the Ailerons and Elevators. This is convenient for removing biases
in knife-edge ight. In addition, a Trim Input Switch convenient for making adjustments during ight can be
used.
▋▋Setting▋Method
The mixing amounts from Rudder to Aileron and Elevator can be set separately for left and right as two
independent settings. It is possible to allocate the switch to a desired position, or use the ight mode switch to
change between two settings.
⿟ Trim Input Function(TRIM IN)
By using Trim Input, it is possible to change the mixing amount using a Trim Lever. Therefore, it is possible to
adjust the mixing during the ight.
▋▋Caution▋Note
⿟ Actually operate the servos and carefully conrm the settings before ying.
Helicopter
Airplane
DANGER
WARNING
CAUTION
Glider
Function▋List
Linked Movement Amounts
to the Left and Right
Operation Condition