49
▋Flap▋Rate【FLAP▋RATE】
▋▋Function▋Explanation
This function sets the maximum up and down movement of the flap control surface angles
independently in each Flight Mode when using the Flap Lever.
It is also possible to set the ap amount against Aileron movement.
▋▋Setting▋Method
Initially, it is set at 0% (default for each ight mode). To change this setting, adjust the numeric value. The
switch for this function is initially set as Flap lever on the side of the transmitter. This can be changed using
the Device Select menu.
▋▋To▋set▋the▋travel▋amount▋on▋FLAP,▋Select▋"FLAP"
▋▋To▋set▋the▋Flap▋operation▋on▋the▋Aileron,▋Select▋"FRPN"▋or▋the▋"FRP2"
※ In case of using Four Aileron, it is also possible to pair them independently and set as following.
①R-AILE1(Right Aileron 1), L-AILE1(Left Aileron 1) ・・・・・ Setting item: FPRN
②R-AILE2(Right Aileron 2), L-AILE2(Left Aileron 2) ・・・・ Setting item: FPR2
When operating a competition aircraft where there is concern regarding mis-operation of the Flap switches or
levers, set the outputs to “0”. Flap operation can still be carried out using other mixing – for example using the
camber system.
▋▋Caution▋Note
Actually operate the servos and carefully conrm the settings before ying.
To Next Page
Loading...
Need help?
General
