23
▋Limit▋Adjust【LIMIT▋ADJUST】
▋▋Function▋Explanation
When multiple channel mixing is used, the resultant servo movement angle may become too
large, and an unreasonable force be applied to the linkages. If limit values are set, it is possible
to limit the maximum movement of the servos, regardless of programmable mixing, etc.
▋▋Setting▋Method
Set the limit values separately for left/right and up/down directions for each channel (servo). Select the
channel using the dial, and press the dial to display the adjustment box.
※ The channel names on the screen will dier according to the model type.
▋▋Caution▋Note
Operate the servos carefully to conrm the control surfaces move as expected before ying.
To Next Page
Loading...
