JR XG 14 - ▋Model Name【MODEL NAME】

66
⿟ Model Erase
Model data stored on the “INTERNAL” memory or SD CARD can be erased. Be sure to double check the model
being erased before continuing.
※ If the currently selected model is erased, the new model creation wizard will automatically start. If wish to use
the current model number, be sure to copy it to another model number rst and erase the particular model by
Model Select.
ダイヤル
TIPS
調整ポイント表示
ポイント接続を曲線に変更 スティック入力位置と出力位置の数値表示
現在の
フライトモード位置
各調整ポイントの
入力位置と出力位置
ポイントの
追加と削除
注意：
グラフはホバリン
グスロットルやス
ロットルトリムで
変化する場合もあ
ります。
カーブをコピー
⿟ The ”TRANSFER” of data between transmitters can be only achieve when the Trainer cable (Sold Separately)
has been plugged in to the XG11 and the transmitter power switch is turned o󱐯.
⿟ When a model transferred from another transmitter is used, it will be necessary to carry out binding with the
receiver again.
▋▋Caution▋Note
⿟ While this screen is displayed, and during copy procedure, NEVER remove the SD Card under any
circumstances. There will be a danger of destroying Model Data which is on the card.
Model selection displayModel selection display
//
Model copy can be selected by INTERNAL, SD-CARD or TRANSFER.
Model in use
Copy SourceCopy Source
Copy Destination
Copy Destination
System▋List