3─102
3
3.10 APPLIED OPERATIONS
y
y y
RADAR Trails Setting
1. File LOAD >
2. File Save >
3. File Erase >
4. Trails Erase >
0. EXIT
[9] NEXT
• The file menu will appear.
Load and save of the Rdar trails.
Procedures 1 Press [RADAR MENU] key twice.
Press [2] key.
Press [9] key.
[1] Loading Trails File
• Presse [1] key.
The saved trail files are displayed.
• Select the file to be loaded
Confirmation warining is displayed.
Select “Yes” for loading.
It takes a few second to be loded.
Note: When the saved trail position is too far from own ship
position, the saved trails can not be loaded.
On the standby mode, however, far trail positions can
be loaded. In that case, the own ship position is
changed to the loaded trail position temporally.
After loading, Range scale, Trails mode
(True / Relative) and Max interval are set to loded
settings.
[2] Saving Trails File
• Presse [2] key.
The File Save menu is displayed.
• Using the cusor, enter the file name and click “ENT”
Confirmation warining is displayed.
Select “Yes” for saving.
It takes a few second to be loded.
Note: When the own ship position data are not available,
trails can not be saved.
[3] Erasing Trails File
• Presse [3] key.
The saved trail files are displayed.
• Select the file to be erased.
Confirmation warining is displayed.
Select “Yes” for erasing.
Note: Deleted files can not be restored, so Erase files carefully.
1 2
3
4 5 6 7 8 90
B C
D
E F G H I JA
L
M N
O P Q R S TK
V
W X
Y Z SP ＜ ＞U
DEL
ENT BS
Save
EXIT
To Next Page
Loading...
Need help?
General
