8─53
Sector Blank
1. Sector 1
ON
2. Sector2
ON
ON
0. EXIT
3. Sector3
4. Make Sector 1
5. Make Sector 2
6. Make Sector 3
7. ENT
[II] Making Sector Function (Make Sector 1, 2, 3)
Procedures 1 Open the Equipment Setup Menu.
2 Press [7] key.
The Sector Blank Menu will appear.
3 Slect the number you want to make
sector blank, pressing the numeric
keys [4] to [6].
The sector blank for the numeric key pressed
will be made.
4 Set the start point of the sector blank
by operating the [EBL] dial, and then
press ENT.
The start angle of the sector blank will be set.
5 Set the end point of the sector blank
by operating the [EBL] dial, and then
press ENT.
The end angle of the sector blank will be set.
Exit 1 Press [RADAR MENU] key.
The Main Menu will reappear.
To Next Page
Loading...
