Juniper MX10004 - Page 187

earthing terminal and below the boom power supply on the rear of the MX10004 (see Figure 75
on page 177).
Figure 75: ESD Point on the Rear of the MX10004
1— ESD point
3. Remove the appropriate fan tray (see "Remove an MX10004 Fan Tray" on page 166).
CAUTION: Do not remove both fan trays at the same me. Remove and replace
one fan tray at a me. If you remove both fan trays, the system triggers a thermal
alarm and shuts down the router.
177