Juniper MX104 - MX104 Routing Engine Auxiliary and Console Ports Specifications; Cable Specifications; Pinouts; Port Cable and Pinout Specifications

Table 57: Ethernet Port Pinouts (continued)
DescriptionSignalPin
Bidirectional–BI–_D35
Receive data–RX–_D26
Bidirectional+BI+_D47
Bidirectional–BI–_D48
Related
Documentation
MX104 Routing Engine Overview on page 21•
• Maintaining the MX104 Routing Engines on page 192
MX104 Routing Engine Auxiliary and Console Ports Specifications
The Routing Engine contains two ports labeled AUX and CONSOLE.
NOTE: The AUX port is not supported.
The ports are asynchronous serial interfaces that accept an RJ-45 connector. The ports
connect the Routing Engine to an auxiliary or console management device.
Table 59 on page 86 describes the RJ-45 connector pinout.
•
Cable Specifications on page 85
•
Pinouts on page 85
Cable Specifications
Table 58 on page 85 lists the specifications for the cables that connect to console port.
Table 58: MX104 Routing Engine Console Port Cable Specifications
ValueSpecification
RS-232 (EIA-232) serial cableCable specification
One 6-ft (1.83-m) length with RJ-45/DB-9
connectors
Cable/wire supplied
6 ft (1.83 m)Maximum length
RJ-45 femaleRouter receptacle
Pinouts
Table 59 on page 86 describes the RJ-45 connector pinout.
85Copyright © 2017, Juniper Networks, Inc.
Chapter 9: Port Cable and Pinout Specifications