3. Insert the appliance coupler end of the power cord into the appliance inlet on the
power supply.
4. Insert the power cord plug into an external AC power source receptacle.
NOTE: Each power supply must be connected to a dedicated AC power
feed and a dedicated customer site circuit breaker. We recommend that
you use a dedicated customer site circuit breaker rated for 10 A (100 VAC),
or as required by local code.
5. Secure the power cord with the power cord retainer clip.
6. Dress the power cord appropriately. Verify that the power cord does not block the air
exhaust and access to router components, or drape where people could trip on it.
7. Repeat Step 1 through Step 6 for the remaining power supply.
8. Observe the LED on the power supply. The LED blinks green as it transitions online. If
the power supply is functioning normally, the LED lights green steadily.
If the LED is red or not lit, the power supply is not functioning normally. Repeat the
cabling procedures.
Figure 27: Connecting AC Power to the Router
Related
Documentation
MX104 Power Overview on page 61•
• MX104 AC Power Electrical Safety Guidelines and Warnings on page 246
• MX104 AC Power Specifications on page 95
Copyright © 2017, Juniper Networks, Inc.116
MX104 3D Universal Edge Router Hardware Guide
To Next Page
Loading...
